Φ 50/75/85mm Hydraulic Cable Cutter, 8 Ton

The hydraulic cable cutter is a small handheld hydraulic tool for cable and wire cutting. Available materials are copper core cable, armored cable and ordinary cable wire, etc.

Specification

Applicable Materials and Cutting Range

Model	Copper Aluminum Cable	Armored Cable	ACSR Cable	Steel Wire Rope	Submarine Cable	Rebar	Iron Chain
T-CPC-50	≤ Φ50mm	≤ Φ50mm	×	×	×	×	×
T-CPC-75	≤ Φ75mm	≤ Φ75mm	×	×	×	×	×
T-CPC-85	≤ Φ85mm	≤ Φ50mm	×	×	×	×	×

Note: × is the not applicable material.

Hydraulic Cable Cutter Structure Diagram

Features

• The hydraulic cable cutter has a hard spring steel blade, which is heat-treated, durable and fast in cutting speed.
• The blade edge can be opened, blade replacement is convenient.
• It is convenient to cut off in distribution box, and can also be used in cutting high-voltage PE, IV cables and telephone lines.

Attention

1. It is prohibited to use this hydraulic cable cutter to cut PC cables and piano cables.
2. Always cut cables within the maximum range of cutting capacity.
3. Do not use hydraulic pumps that exceed the maximum load of tool handle.

Tips: Use hydraulic cable cutter to cut cable wire.

1. After putting the material to be cut into hydraulic cable cutter, close the upper blade. Check whether the movable pin of jaws has been completely inserted into the hole.
2. After preparation work is completed, tighten the oil return bolt. Hold the grip of handle firmly with both hands and swing the movable handle until cable is cut, then complete the first cutting operation.
3. Loosen the oil return bolt counterclockwise to quickly reset the lower die seat and piston.
4. If you need to cut again, repeat the above steps.