Best pneumatic scissor for sale online, is an air shear tool with small size but strong impact resistance, used for metal cutting in large production lines, electricians, repairs, hardware, and auto repair.
Specification
Model |
T-HS5-S2S |
Maximum Cutting Capacity |
1.0mm Copper Wire
0.5mm Iron Wire
|
Air Consumption |
64cm³/ cycle |
Operating Air Pressure |
73-87psi |
Applied Pressure |
390N |
Air Inlet Size |
5/16 Inch |
Recommended Hose Inner Diameter |
5mm |
Applicable Hose Size |
5*8mm |
Overall Length |
150mm |
Net Weight |
0.18kg |
Package Weight |
0.35kg |
Details
|
A. overall length: 64mm |
B. thickness: 7mm |
E. working length of blade: 13mm |
F. working angle of blade: 0° |
G. V-shaped upper end: 4mm |
H. V-shaped bottom end: 2mm |
I. maximum width of knife arm: 17mm |
J. maximum thickness of knife arm: 4mm |
K. minimum thickness of knife arm: 1mm |
L. front end length of screw hole: 24mm |
width of closed shear: 16mm |
extending length: 17mm |
Installation of air nipper blade
- Put the blade into the air nipper body.
- Align the bolt and put it in.
- Tighten the nut.

Tips: 4 tips for using air nipper to cut 1.0 mm copper wire
In order to keep your pneumatic nipper air tool in good working condition for a long time, please maintain air shear according to the following items.
- Use air with proper pressure: Please use the working air pressure in the range of 73-87psi. If the working pressure is too low, the working efficiency of the air shear will be significantly reduced or even fail to work normally. If the air pressure is too high, although the working efficiency of the air shear can be improved, it is easy to damage the internal parts and shorten the life of the air shear.
- Use filter: The moisture, dust, rust and other foreign objects in the air are the main reasons that cause premature aging of air scissor parts. Therefore, it is necessary to install a filter for the pneumatic scissor. Filter foreign matter in the air to provide clean and dry air for the air cutter. The filter must have enough flow and be cleaned frequently, otherwise it will affect normal operation due to insufficient flow.
- Lubrication of air shear: Air shear and other air tool must be properly lubricated regularly to ensure normal and long-term work. Put 3-4 drops of lubricating oil into the air inlet of the air nipper before and after each work.
- In addition, after working for a period of time, the air compressor that powers the pneumatic nipper will accumulate a large amount of water, and the water must be discharged regularly to ensure the air is dry.